00:00So I've made another model. This one is a copy of Super Mario 64's starting level in the Peaches Castle.
00:07So we'll put that card in and we will start it up.
00:11Let's turn that on.
00:14And we'll wait for it to start to warm up.
00:17And we should be able to print this.
00:19Stealing up, getting ready to go.
00:23Alright, it's getting ready.
00:25From here, it's extruding some filament.
00:32I'm not supposed to cut that off, but I think it's cleared itself up.
00:45And there we go, starting to print this little tiny bit at the moment.
00:49And just the outline around.
01:21So, what's the problem?
01:35So here we are, we've got Peach's castle. As you can see unfortunately most of the terrain
01:42didn't get printed for any reason. It couldn't print in the slices so it just removed that
01:47but it's kept all the support here so if it did print it would be there. A bit of a
01:52shame. Put the
01:54terrain here even though that's super thin. Actually that's why they couldn't do the rest of it because
01:58it's basically only one layer thick and on an angle that'd be impossible. This piece here is like solid
02:04where it sort of goes down. For the actual castle it turned up pretty well. A bit of a sideways
02:11bit
02:11there. You can see they've got the bridge over the little moat thing. The spies, the towers,
02:17doing that quite well. Let's see if we can break this off. Let's be careful. Hopefully I don't
02:23snap the whole thing in half. There it looks quite thin. It's sort of stuck on there.
02:41It's quite a big print area so there's quite a lot of adhesion on the mat here.
02:51Let's try to get this all off.
03:00There it goes. Very bent. Hopefully if I just put it on it the magnetism should fix it up. I've
03:08seen
03:08replacement ones of these for some of the other models which are about $10 each is expensive and
03:13they'd have holes in the corners so maybe it's to go over those because that affects the printing area.
03:20There you go. You can see where that one was printed. Let's take a look at that there. Let's have
03:25a look at
03:25the bottom of this print. You can see again little bits have been picked up.
03:31And so I'm not sure how long this is going to last.
03:37If it doesn't maybe you can try the glue method. Maybe with something else like a regular magnet or
03:43something. Here it is. Here is the castle. That's it for this video if you like. If you'd like to
03:49comment down below your thoughts and subscribe to some series like this in the future.
04:09And see you next time.
04:09Have a great day.
04:10Bye bye.
04:10Bye bye.
04:10Bye bye.
04:12Bye bye.
04:13Bye bye.
04:13You
Comments