Skip to playerSkip to main content
Will 15mm or 20mm wheel spacers cause rubbing on a 2017 Tesla Model S? We test-fitted both sizes, measured the clearances, and ran the full-lock steering check on camera. Short answer: no rubbing at either size on this stock-height car, but here's exactly what you should check before assuming the same for yours.

First, the starting point: a straight ruler against the fender showed about a 20mm gap to the tire edge, front and rear. That gap tells you how much room you have for the look, but it does NOT tell you whether the tire will rub. Rubbing depends on wheel offset, tire width, suspension travel, and how much clearance remains when the steering turns.

THE 4-POINT RUB CHECKLIST (before you drive)
1. Measure your fender gap first (ruler against the fender edge)
2. Test-fit the thicker size first, look and clearance
3. Full lock-to-lock steering, inspect fender liners both sides
4. Check through suspension travel if lowered

⏱ CHAPTERS
0:00 The answer first: no rub at either size
0:35 Starting point: stock fender gap
1:19 20mm test fit, aggressive vs rubbing
2:02 Full-lock interference check (both sizes)
2:41 The 4-point rubbing checklist
3:20 Full install video next

🔩SPECS ON THIS CAR
• 2017 Tesla Model S, stock height, stock wheels (5x120, CB 64.1, M14x1.5)
• Fender gap: ~20mm front / ~20mm rear
• Tested: 15mm and 20mm spacers — full-lock check, no contact at either size
• Caliper-to-spoke gap: 15mm stock → 35mm with spacers
• Spacers: BONOSS Forged Active Cooling, AL6061-T6, hub-centric, bolt-on
• Studs ~38mm / wheel pockets ~27mm — no stud cut
• Torque: 140 N·m (BONOSS Grade 10 nuts) / 175 N·m (factory nuts)

FAQ
Q: Will 20mm spacers rub on a Model S?
A: Not on this stock-height car, full-lock test on camera. Lowered cars or wider tires need their own check.
Q: Does a bigger spacer automatically mean rubbing?
A: No. Aggressive look and rubbing are different things, this video shows both sizes clearing.
Q: What should I check on my car?
A: The 4-point checklist above, measure, test-fit, full lock, suspension travel.
Q: Which size did the owner keep?
A: 15mm front / 20mm rear, preference, not rubbing.

Product page: https://www.bonoss.com/product/bonoss-forged-active-cooling-hubcentric-wheel-spacers-pcd5x120-cb64-1-al6061-t6-for-tesla-model-s
📺Series:
▶ Full install + stud clearance → https://youtu.be/GRrurwx2byc
▶ How we picked the size → https://youtu.be/ANX0DsGa51o

#wheelspacers #teslamodels #rubbing

Category

🚗
Motor
Transcript
00:00Will 15mm or 20mm wheel spacers cause rubbing on a Tesla Model S?
00:05A thicker spacer pushes the wheel farther outward,
00:08but that doesn't automatically mean the tire will rub.
00:11On this 2017 Tesla Model S, we test-fitted both sizes,
00:16checked the wheel position, and inspected the clearance during steering.
00:19Let's look at what we found and what you should check
00:22before choosing a spacer size for your own car.
00:24Before installing any spacers, I started with the original wheel fitment.
00:28I used a steel ruler to measure the gap between the fender and the outer edge of the tire.
00:33The measured gap was about 20mm at both the front and rear.
00:37That gave me a useful starting point for deciding which spacer sizes to test.
00:42But here's the important part.
00:44The fender gap alone doesn't tell you whether a tire will rub.
00:47You also need to consider the wheel offset, tire width, suspension movement,
00:52and how much clearance remains when the steering is turned.
00:55Based on those initial measurements, I decided to try a 20mm spacer first.
01:00The goal was to bring the wheels farther outward and see how the fitment looked on the actual car.
01:05After test-fitting the 20mm spacer on the front, the wheels sat farther out than the owner wanted.
01:11That's an important distinction.
01:13A wheel can look too aggressive without necessarily having a rubbing problem.
01:16So instead of assuming that 20mm was the right choice,
01:20I compared the fitment and checked the available clearance before making the final decision.
01:25So, what's the actual difference between 15mm and 20mm?
01:29The 20mm spacer moves the wheel outward 5mm farther than the 15mm option,
01:36assuming the same wheel and mounting setup.
01:38That extra 5mm can change the way the wheel sits relative to the fender.
01:43For this Model S, the owner preferred the more conservative front fitment.
01:47So the final choice was 15mm up front and 20mm at the rear.
01:52Next comes a critical step, checking for any actual interference.
01:57Once the spacers are installed, turn the steering system to its full-lock position,
02:01both to the left and to the right.
02:04Carefully inspect the clearance between the tires and the fender liners,
02:07as well as any surrounding components.
02:10In the case of this vehicle, there was no rubbing against the fender liners or adjacent parts
02:15when using either 15mm or 20mm spacers.
02:19On this 2017 Model S, the owner chose 15mm at the front and 20mm at the rear after comparing the
02:27fitment.
02:27The takeaway is simple.
02:29Measure first, test the actual setup, and check more than just how the wheels look from the side.
02:34If you're planning wheel spacers for your Tesla, check the complete fitment before driving.
02:39And subscribe for more real-world wheel spacer tests and installation videos.

Recommended