00:00I have just put this piece of paper on the top of the print bed. Hopefully I'll stop the petji
00:05from ripping it up as I print.
00:07I can just throw this out because there's some piece of scrap paper that's already been used from other stuff
00:11on the other side.
00:12So I'm not really worried about it.
00:14I've just stuck this on with a glue, a little tiny little bit to hold it in place so hopefully
00:18it doesn't come off by itself.
00:19And also hopefully I can just easily remove this.
00:22So let's turn it on.
00:27I've already put the SD card in with our model for our 3D Buddha.
00:34Let's start that up.
00:37Let's wait for it to heat up and we can see how this print turns out.
00:55Let's see.
02:43Let's finish this 3D print.
02:47Let's take it off.
02:50Bit heavy.
02:52This is the wooder.
02:55Turned out quite well.
02:59Solid.
03:00There's a few lines from where I didn't adjust the filament.
03:03So it's sort of sheer food because it was sort of pulling on it.
03:06Other than that, it turned out mostly well.
03:08There's one shift line.
03:09There's another one there.
03:11Probably one more somewhere.
03:14Let's see if we can peel off the paper.
03:20Oh well that's not very good.
03:23That's coming off but also the paper where I glued it on here is coming off where I glued it.
03:30I can probably slowly peel that off.
03:36There's also some bits stuck there.
03:37Why I didn't put any glue?
03:39Maybe it's stuck on these.
03:41It's remelted.
03:41I'm not exactly sure.
03:43There's a little piece of filament here.
03:48I'll probably just have to maybe use a little screwdriver to scrape it off or something.
03:54I can focus on that later.
03:56Let's have a look at our actual model.
04:04Let's peel that off.
04:05I'll probably have to take this off as well.
04:08Maybe I could just put this in water and use that to help break down the paper to take it
04:12off.
04:13Here's the bottom.
04:16I did this so it would have less contact with the base.
04:19So it wouldn't stick as much.
04:21But I think it was good regardless of whether I'm using the paper or doing drilling onto the printer bed.
04:25It was still a bit of curving where it sort of warped at the bottoms here.
04:30You can see there it's gone up.
04:34Let's see even more on that side.
04:37There's a bit of wobble there.
04:39It hasn't turned out too bad.
04:44There we go.
04:45It's actually I think pretty good.
04:47It's also very light.
04:48So we had 10% infill.
04:51That's not too bad.
04:52A bit brittle there as well.
04:55Sort of here clicking.
04:58Yeah, it's pretty good if you ask me.
05:01I'm going to leave this video here.
05:02If you like the video, comment down below your thoughts on these videos.
05:04And subscribe to see any videos like this in the future.
05:25We'll see you again next week.
05:27Bye, bye.
05:38Bye.
05:41Bye.
Comments