00:00Hello everyone, we meet again this week.
00:03Recently, I've been particularly fond of various ingredients.
00:06So this week, I'm going to indulge a bit and teach you
00:08all about the squid that I've been really into lately.
00:11About the introduction, let's just get started.
00:13This work requires a square piece of paper that is 15 centimeters on each side.
00:17First, we need to find a few points on the edge of the paper and fold a diagonal line.
00:22After opening the diagonal line, we fold this edge toward this diagonal line.
00:31Note that when folding, what we want is the position left by this tip.
00:39So just gently press down a bit, and there you have it.
00:43Then, fold the upper edge towards this point.
00:52Note that this line should be folded parallel.
00:56We can turn it over and fold it carefully.
01:03Fold it over like this, and this point will
01:06land exactly on the bicolored boundary line.
01:15With this line in place, fold the edges together.
01:22Find its axis of symmetry.
01:26Open it up.
01:29Fold both edges towards the middle line.
01:34Notice that at this point, since the bottom layers
01:39are folded together, this part might wrinkle.
01:43It's okay, we'll open this part up later.
01:47Open it up.
01:49Then open up this edge.
01:52Fold the edge towards the line.
01:55Diagonally.
01:59Make sure it's symmetrical on both sides.
02:09Alright, after folding, pay attention here.
02:12There's an intersection here on this crease.
02:15Then, there's another intersection where this crease meets the edge.
02:19Fold along the line connecting these two points.
02:26When folding, you'll notice that the middle angle falls right on this line.
02:30Make sure it's symmetrical on both sides.
02:48After folding, fold the entire piece back along the bottom line.
02:51Then, flip it over.
03:02Fold this edge towards this line.
03:05The bottom part is thicker.
03:13Be careful when folding.
03:17Try to avoid too many wrinkles.
03:19Now, fold the triangles.
03:28After folding, fold this part down along the bottom line.
03:31There you go! It feels a bit like folding a paper airplane, right?
03:44Then flip it over. Fold along the center line on both sides. Does it look more like a plane now?
03:54Pay attention here! Fold this tip towards this point.
04:01Fold it. Open it up. Then, fold a line from this intersection to this point.
04:13From this intersection to this point.
04:23After folding, open it up from the center. Press this part flat.
04:31Then fold it like an origami crane.
04:47Fold both sides toward the center line. Leave a crease first.
04:52Then, fold these two parts to the center along the crease.
05:03Just like folding a crane.
05:04You can open up the upper part now. No need to fold through the thick layers.
05:20Just press it flat here along the previous crease.
05:22The upper part is like this. This is the head part of the squid.
05:34Then, close it up.
05:35After closing, look here. Fold this edge towards this edge.
05:43The other side is the same.
05:57Then, fold the white corner from the bicolored boundary line upwards.
06:11Then, fold the white corner from the bicolored boundary line upwards.
06:14Fold it, open it up, and tuck this square into the middle.
06:27Then, fold this line upwards to form a triangle.
06:30Fold it again along the previous crease, tucking the triangle into the middle.
06:43Make sure this part is sharp.
06:45Then, similar to before, fold the bottom corner upwards and then fold it back down from the center.
06:58Next, open it up.
07:16Fold this middle line of the triangle towards this edge.
07:21Push it out and fold it towards this edge.
07:23Press it flat.
07:32After pressing it flat, two angles will appear here.
07:37Fold these two angles again.
07:40Following the same pattern as before, tuck them inside.
07:53One angle and the other angle.
08:07Make it sharp.
08:11Alright, two branches are completed.
08:15The back part is the same.
08:18Fold the white triangle and fold it along the edge to the top.
08:24Fold the white corner diagonally.
08:51Now, there's a large right triangle in the middle.
09:05Fold it down along the edge, similar to before.
09:17Fold the bottom corner upwards along the edge.
09:32Fold the middle part down last.
09:48Alright, now the 6 tentacle branches are completed.
09:55Fold the tip downwards.
10:02Next, look here.
10:10Fold this edge from the midpoint of this line to the midpoint at the bottom.
10:16Fold this left edge towards this line.
10:26With this line in place, fold it back in the opposite direction.
10:34Open it up from the middle.
10:35Alright, pay special attention to the next step.
10:40Fold it from both sides here and gently pull the bottom part open.
10:49Let this line pop out.
10:53Then tuck this line in.
10:56Note that this part is not shown in the folding diagram.
11:00Make these 2 lines pop out.
11:06After popping them out, tidy it up to look like this.
11:13Leave the bottom part open for now, we'll deal with it later.
11:18Pop the middle part out.
11:21There you go, it should look like this.
11:24It should look like this now.
11:28Like this.
11:29Then, push these 2 points inward.
11:37Push them in.
11:41Then pay attention, close it like this.
11:47It should look like this.
11:49The middle part is now 3 dimensional.
11:52On both sides.
11:55Pinch these legs together first.
12:02Tuck it in.
12:03Not really tucking, just close it like this.
12:07Like this.
12:10The shape of the squid is now complete.
12:20Tuck it up a bit more.
12:26You can curl the back legs a bit.
12:31Scrape it with your fingernail to loosen it up.
12:36There are 6 tentacle groups in total.
12:51The front looks like this.
12:53The back looks like this.
13:01You can press a bit here to make it tighter.
13:07It's okay if you don't press it.
13:08bamboo all over there.
13:08There you have it, the squid is now folded.
Comments