King Cobra Origami: Fold a 3D Snake That Stands, Hisses and Strikes! | Full Step-by-Step Tutorial - video Dailymotion

flowercraft85

Turn one sheet of paper into a life-like king cobra that stands on its own, flares its hood and even lunges! In this mega-detailed walkthrough I slow down every fold, crease and reverse-pinch so beginners and pros can both finish with a snake that looks ready to strike. What you will get: Printable 2:1 rectangle template link (free) Hood, fang and scale details without cuts or glue My secret “S-curve” tail trick for instant 3D posture Tips to make the cobra hood snap open in one pull Follow along, post your finished serpent on Instagram or Twitter with #CobraFold and I will feature the best ones in the next video. Grab your paper and let us make something dangerously cool! king cobra origami, 3D snake tutorial, paper cobra that stands, origami snake hood, step by step snake fold, easy king cobra paper, origami animals for beginners, paper snake craft, foldable cobra, snake origami without cuts, DIY paper serpent, origami reptile tutorial, king cobra paper model, stand up origami snake, printable snake template

Transcript

00:00fold this half and half right down the middle open it up then fold both sides to the center

00:11fold these two corners in half open it back up and push this corner inside do the same on the

00:19left push and fold in then fold both corners down nice now rotate it fold this head part over to

00:30the left line this edge up with this edge same fold on this side from the cross crease fold down

00:41open here and push fold inside same push fold on the left fold this edge left this edge to center

00:51open this edge to center too pinch a little point in the middle and fold down

00:58fold this back same on this side fold over

01:04nice now rotate fold this part up fold this tip to center left tip to center too fold down here

01:23this is the mouth fold down half here these are the teeth same on left you can pinch teeth to a point

01:31flip it over fold the head like this open and do same fold on other side fold this point to the

01:42cross point same on top here fold this edge to center line top we push fold to cross point here

01:53same on this side same on this side now fold down like this fold head down a bit

02:06now fold here make a crease mark then open it open and fold up

02:22reverse fold fold it inside like this

02:26now tongue tip fold a small corner in fold this bit in and that is it

02:35after folding curve this part a little you can smooth it with fingers press and roll with fingers

02:42all good tail can be s-shaped or coiled your choice cannot wait to see your finished king cobra

02:49okay

King Cobra Origami: Fold a 3D Snake That Stands, Hisses and Strikes! | Full Step-by-Step Tutorial

Category

Transcript

Be the first to comment

Recommended