00:00Hello and welcome. Today I'm going to show you how to assemble your V2 virtual
00:05boy tripod kit. Tools that you'll need is a screwdriver with a flat tip. If you
00:17happen to have a specialty toolkit you can also use a U10 specialty bit but I
00:29would strongly recommend a flathead screwdriver. So to actually disassemble
00:35it the only thing you'll need to take out are the black components. First thing
00:39you'll take out is going to be the wing bolt right here and you'll take your
00:45flathead screwdriver and you'll take out the half-inch bolt that's in the back.
00:54Next you're going to look for the markings on the bottom you'll see that
00:59it'll have correspond with the correct side you have A side A side then you'll
01:03have B and B side. We're going to work with A side first and we're going to put
01:08the A side in with the A side bolt like so. Don't tighten it too much these are
01:18plastic screws just enough that it feels snug. Next we're going to take the B side
01:24we're going to take our wing nut and then we are going to tighten it down tight tight
01:32tight tight all the way until it makes it to the bottom and you'll know when it's on
01:41the bottom when it can kind of spin a little freely like so. Next we'll take the B side and
01:48we will hold it a little in place until it levels out with the bottom and screw
01:55all the way down until it flattens out like so. And to use it it's as simple as
02:03taking clipping virtual boy upside down unscrewing the bolts and notice how it
02:10slides out putting it in and I recommend bolt side facing to the front of the unit
02:16then tightening it down. It's snug enough that you can pretty much dangle this
02:23however you see fit. All you'll need now is to take a tripod like this little dinky
02:33one and just screw it into the bottom of the unit and now you can play virtual boy
02:48on any conventional tripod.
Comments