00:00This is how we make our original Virtual Boy Tripod Kit.
00:04First, we 3D print the parts in their respective colors.
00:07Then, we begin assembly by press-fitting in the quarter-inch nut.
00:11Then, we screw in the one-inch bolt and put in a stopper.
00:16Next, we hammer in the three nuts and thread in the elastic.
00:20Then, we attach the bottom by screwing in the two half-inch bolts.
00:25Next, we attach the A-side of the clamp with the remaining bolt.
00:28And finally, we slide down the B-side and hold it in place with a wing nut.
00:33And when we're done, we can attach it to a tripod, unscrew the B-side's wing nut,
00:38and put in the Virtual Boy and tighten it down, and you're good to go.
00:43Before we ship the units, though, we lightly disassemble them and put them into a bag.
Comments