00:00Hello and welcome. Today I'm going to show you how to assemble your brand new Virtual Boy tripod adapter.
00:09All you'll need to assemble it is a screwdriver with either a PH2 or a PH1 tip.
00:16To start, you're going to take off the wing nut on the back of the tripod adapter.
00:22Then you're going to take out the three screws.
00:31Next, you're going to take the bottom of the adapter mount and put it nut side in like a sandwich.
00:43Take your two screws, put them into the holes like so.
00:49Then you're going to tighten them until they feel nice and tight.
00:57Make sure that they're properly aligned. You don't want to cross-thread these by accident.
01:03There we go.
01:06Next, you want to take the A side and you can tell which side is which based on the markings.
01:12You'll find a marking on the top of the unit as well as inside the holes.
01:16So, you're going to put the slot in like so, hold it in place, put the bolt into the back.
01:23Then, you're going to tighten this guy down until it feels, again, tight.
01:32Finally, you're going to take the B side and put it into the B slot.
01:36Pulling down on the elastic and you're going to take the wing nut and you're going to just slide it
01:45right down to the base.
01:49Like so.
01:53To use the Virtual Boy adapter, all you'll need is a Virtual Boy, whether the Nintendo Switch Online accessory or
02:02an original unit.
02:03And to attach it, you'll attach it exactly where the original adapter goes.
02:07I'd recommend having the bolt side out.
02:10You're going to loosen the front until it's able to fit.
02:13About four or five turns should be enough.
02:15Then, you put it down and one, two, three, four, and then five.
02:21And then, you tighten it until it feels snug and you are good to go.
02:26So, all that's left to do is to put it into a tripod, like this little one that I got
02:33from a dollar store.
02:38And, you are now good to go to play the Virtual Boy on whatever mains you want.
02:46From the open, y'all?
02:46I'm proud of you.
Comments