00:00the dual temp glue gun sure bonder plus now I myself never use this but I've been
00:15looking for a way to seeing it's about 10 degrees at night outside this thing
00:27keeps sliding down and I know I need one of these clamps just to keep this end I
00:43wonder if that glue gun would do that job let's say first we'll cut it out of the
00:51package without destroying anything this is the smaller unit so they give me about
01:10what's that ten twelve six I noticed here you're not exposed to moisture you're not
01:24use where is that structural fasteners do not use hot melt glue to replace I'm
01:41just looking for like a temporary fix now it's got here the H and L high and low
01:52switch trigger stand support pulls out like that slide fins okay
02:22yeah let's see operating plug an outlet insert 27 diameter mini glue stick into
02:32inlet allow the gun to heat for five minutes squeeze trigger to dispense glue more
02:41glue is dispensed by squeezing trigger again continue glow flow by adding additional
02:51glue sticks requires approximately two glue sticks for initial startup press surface to glue to be glued
03:05immediately do not pull glue stick from gun if changing glue feed remainder of glue stick through gun unplug
03:15after use allow cooling before being stored gun will not heat up make sure glue gun is plugged into 120 outlet
03:22make sure glue gun is plugged into 120 outlet okay all right so let's give this a try take off the
03:37the tie here now there's an outlet right next to let's see here on the chair here so I think I'll just move the
04:07chair and let it sit on the floor
04:09be right back okay ready to work so we'll see the hole in back push the first stick it said it'll probably use two sticks to fill up
04:28let me put that in
04:35push it all the way in
04:55I'm squeezing it now
05:02yeah that when you squeeze the trigger you see that little part pushing it so it says it might need about oh there it is
05:16all right let me just pause this and we'll go right to our repair okay here's our repair
05:25let's try to get the best lighting but uh right here
05:35that may be enough but I'm gonna put the second stick in never use one of these things but I did want to get one at one point
05:56see if that stays in
06:03just a temporary fix
06:05and now let's wait set it on the paper unplugged yeah and you may not want to open this completely because you can keep your
06:20blue sticks in there or maybe if you had a rubber band I think I'll be putting the whole gun back in there
06:29now uh this switch here always was able to slide under it so with this flush on the top I used to be able to pry this up and that
06:50see that little latch would go under there perfectly but then this piece would pop out and it's not popping out yet
07:04that's pretty solid piece of plastic there
07:09okay this may work but I wanna do it easy yeah perfect I went to the other side and with my right hand at the same time I hit it
07:23now that's in there deep okay and that hasn't budged very good we'll leave in this description
07:34if uh
07:36if uh
07:38any problems occurred but yeah that's pretty strong gun
07:41the glue uh
07:43settled in uh
07:45held uh very fast
07:50so I'm pleased with it
07:52and that will be
07:54I'm not gonna say review
07:56I just wanted to show
07:59what's in the box and or container and
08:03how it worked for me
08:08it's all cooled down already
08:13then you can be your own judge on it
08:16I did have it on high
08:19it's got the two settings
08:21okay thanks for watching the video
08:23take care
08:24take care
