00:00turn your printer into a pumpkin patch this Halloween this pumpkin bowl can be
00:06used to hold a candle candies or whatever you like the shifted layer will be discussed later
00:11in this video here's the cover and also a green top you can push it on the cover without using
00:20any glue please subscribe if you like it thanks the pumpkin itself was printed in one piece with
00:39so-called tree supports here's the shifted layer let's see how that looks in bamboo studio let's
00:50check the layers of the shifted part here you see the height at which all layers are correctly
01:01positioned again and this is the height where the shifting started you can also inspect one layer
01:09with this slide at the bottom the tree supports may have caused the layer to shift slightly let's go a
01:23little higher here you see the layers that did not shift but were also supported by trees this is the
01:34line where things lined up again what do you think it could be you might also want to check out my 3d
01:41design channel see you there
Comments