00:00Hello. Let's see today. I'll explain how to check the inverter compressor. You need a good meter. Check this out. Here's a good meter. Notice the terminals. There are three. U, V. Attach it to W. The readings should match.
00:20First, check for a shot somewhere. Ensure it's not shot from the body. Look at this. Point six is shown. We have to connect it this way. Connect to the grip. You'll use it with the prop, correct? No carbon joints or readings will be wrong. Check this out.
00:50All three readings should match. All show five. Look at this now. Five. First, check the chest rubber feeding. Then the motor testing follows. This makes the IBM heat and causes problems in the circuit.
01:10Notice the important relation. This is meter meter. Check this out. You should observe this. Set it to 250. It needs to be 1000. It can deal with 500 volts. It will also work for your 200.
01:28So it must be placed in the same location. Look at this prop and connect it like this one. So right.
01:43Up to that, then install this emergency button. See, this reading appears on the gauge.
01:51Gauge.
01:52This way the reading will go through. You must check it there. Observe this reading.
01:57The upper reading is going down. See this. Look. The probe is set up here.
02:07This reading shows it's testing the motor internally. Look at the body and the motor. See this.
02:16Check it this way. See.
02:18This reading should be on the gauge. See.
02:23Look at this. See the bar pressure here.
02:26All three readings should match on the gauge if they don't see.
02:35In the gauge, check the readings carefully. They should align.
02:39I am here.
02:46Baseball bat.
02:59Upon.
02:59Yes.
03:01Yes.
03:02Yes.
03:03Yes.
03:04Yes.
03:05Yes.
03:06Yes.
03:07Yes.
03:08Yes.
03:09We do this with it, and after doing this, we turn it off immediately, because it generates voltage by itself.
03:22Take this.
Comments