00:00Assalamualaikum Ji.
00:02Today I am going to show you how to check the compressor of an Anvator.
00:08For this, you need to use a good meter.
00:11This is a good meter.
00:13You can see its terminal.
00:15You can see all three terminals are connected to UVW.
00:18The readings should be the same.
00:20First of all, check the short from somewhere.
00:23It should not be short from the body.
00:26You can see its reading is 0.6.
00:30Now we have to attach it like this.
00:37You have to attach it to the grip.
00:39If you use it with a prop,
00:42and it does not join properly with the carbon,
00:46the reading will be wrong.
00:48You can see.
00:50The readings of all three terminals are the same.
00:54Now check the readings of all five terminals.
00:58Check the readings of all five terminals like this.
01:01After this, there is a testing of the motor.
01:06Because of this, the IPM is also heated.
01:09And there are many problems.
01:11Because of this, you face a lot of violations.
01:15This is a meter meter.
01:18You have to keep it at 2500.
01:22You have to keep it at 1000.
01:24Or 5000 voltage.
01:26It can also withstand 2500.
01:29You have to keep the meter.
01:31And this probe is a dangerous system.
01:34Because it produces 2500 voltage from itself.
01:38You have to put it in such a place
01:40where you have to put this probe and join it like this.
01:45After that, they have put this emergency button.
01:48This reading comes in the depth.
01:51It will go.
01:52Similarly, this reading will go in all of them.
01:55Okay.
01:56You have to check it in it.
01:58See.
01:59Now see the reading is going down slowly.
02:02See.
02:03When there is a problem here, see this.
02:07It is giving this reading.
02:08It is testing the motor from inside.
02:10From the body and motor.
02:12See this.
02:13See this.
02:16You have to check like this.
02:18See this.
02:20This reading should be in the depth.
02:22See.
02:23See this.
02:24See this.
02:2512.13
02:26The reading of all three should be in the same depth.
02:30If it goes in the K or MEG.
02:33See this.
02:34Can you see?
02:35See this.
02:36The reading goes in the MEG.
02:37See, I have put it on all three probes.
02:39On the points.
02:40On the UVW.
02:41This reading should be this much.
02:43If its reading comes in the MEG or K.
02:48Then the motor of the compressor is not working.
02:51See this.
02:52You have to check it in MEG.
02:54Do not check it without MEG.
02:56This is a MEG meter.
02:58See this.
02:59The voltage comes out from here.
03:03See this.
03:07I have switched it off.
03:09And see again.
03:13See this.
03:14With this we do MEG.
03:16After doing MEG, we switch it off.
03:19Because the voltage itself generates from it.
03:22See this.
Comments