00:00Assalam-o-Alaikum, this is a 1-tonne Kenwood kit, it has 1 or 1.5 or almost the same errors.
00:23As you can see, 20 errors are showing.
00:26This 20 error is due to the fact that the DC motor is not working properly.
00:38The motor is fine, it is not jammed.
00:42But it is not getting the current from the back.
00:47Because of this, it is showing 20 errors.
00:50We will repair it.
00:51In this, most of the capacitors get damaged.
00:54You can see this SMD here.
00:57You can see this in the camera, it can focus.
00:59You can see this in the camera.
01:01This gets damaged most of the time.
01:03So in this, the error 20 is shown.
01:07If you change this or check its motor, then your 20 error is finished.
01:15I try to make this video as short as possible.
01:18So that we don't waste your time.
01:25This is a very special video.
01:28In this, you must have understood that the 20 error is due to the motor error.
01:33And if changing the motor ends the error, then it is fine.
01:40Otherwise, you can check its voltage.
01:42This is the first pin.
01:44This is the first pin and this is the pin ahead.
01:47This is the ground voltage.
01:48This will get 350-300 volts.
01:50This will get 15-15 feedback voltages.
01:54This is the problem.
01:56If there is any other problem, then you can trace the line from the back and check.
02:01If you like the video, then like and share it.
02:04And subscribe to the channel.
02:07Thank you for watching the video.
02:08Goodbye.
Comments