00:00 and then it comes out all the way. The important thing is to find where to put the new and the old roller.
00:08 So here we agree, this is the new one, this is the old one.
00:11 Yes, that's it.
00:12 So after I take the plastic part.
00:14 The new one is still there.
00:15 I take the plastic part, I remove it, I take my new roller, I have the first part which is blue.
00:23 I put this in, I clip it, I turn it, I do the same assembly, I put the white parts here, it turns, it's normal.
00:31 I try to turn it a little bit at the beginning to make it bite and take it.
00:37 I turn it a little bit to stretch it, if it's not super tense, it's okay.
00:41 It's better if it's tense because when you put it back on.
00:44 If it's a little like that, it's okay, but the best is to take a little turn.
00:47 Then I have a notch at the bottom, in the middle, I have two points, in fact I have the opposite.
00:55 So there it goes back very quietly, I go slowly and there I just push and it starts again.
01:01 And it will move back and synchronize itself without any problem on its own.
01:05 Okay.
01:06 It's not very complicated.
01:08 It's not very complicated, it's good.
Commentaires