00:00first step to do is to wash your brows with the blue soap solution in your foam bottle
00:04usually done by mixing your blue soap in with water in your foam bottle
00:08that's the first step to doing brown lamination after that you clean your brows with wipes
00:12then use cutting wipes to make sure it's very dry we need it very dry for the next step
00:16this is the lamination kit i'll be making use of the first step we'll be making use of the
00:21pem solution also known as step one make sure the client's brows are dry before this application
00:26apply thoroughly on brow hairs only avoiding the skin be generous with your step one as this
00:31relaxes your client's natural brows apply step one to both sides of the brows after which cover with
00:36film tape make sure the coverage is airtight total time for step one is 10 to 15 minutes depending
00:42on the nature of the client's brows then five minutes into the time lift your film tape brush
00:48through to ensure the pem gets to the root of your brows that is it's touching every natural hair
00:53brush upwards and downwards it is important to wipe your step one with a dry wipe or a cutting pad
01:00before application of step two clean upwards if done properly your client's brows will be looking
01:06this relaxed if you feel like you can brush upwards before applying your step two the next step is to
01:11apply your fixation solution also known as step two don't forget to be generous while applying your
01:17solutions apply to both brows again apply to natural hair and not to skin you could make use of
01:23cutting boards for application always make sure you're applying upwards enable the air relaxed in
01:27that direction they cover with film tape the total duration for step two is eight to ten minutes once
01:33again five minutes into the step two take out your film tape and brush thoroughly make sure the solution
01:38sits properly on the brows remember to wipe with dry wipe or coating pads don't forget to clean your step
01:44one properly before step two and step two before mapping the next step is mapping out the desired shape
01:50you can do this next step before mapping or while you wait for step one or step two you can
01:56put two
01:56drops of your tints in a bowl or container then apply your developer for this illustration i'll be using
02:03the black tints in any mixing ratio of tints whether black and coffee brown the developer is always higher in
02:10ratio thus two drop of tints three drops of developer mix properly till it blends it can be kept aside
02:18while you
02:18carry out the other processes the next step is mapping the inner corners of the brows is usually
02:2410 millimeters apart the highest part or the arc of the brows was determined by the client's
02:30arc bone the tail or the end of the brows was measured 8 millimeters using the mapping ruler
02:37the reading on of the arc on the map rule was 5 millimeter the brows was drawn using mapping pen
02:44it can be cleaned and redrawn
02:45to suit the client's preference same thing was done to the second brows the distance between the two
02:51lines were 10 millimeters apart the arc was gotten from the highest point of the client's arc bone it was
02:58reading 5 millimeter the tail of the brows or the end of the brows was reading 8 millimeter and yes
03:05the
03:05brows could be drawn without the mapping rule drawing with a map room gives the guideline to a more symmetrical
03:11look
03:12like i said earlier corrections could be made using your applicator swap or wooden swap as seen in this
03:18video it is important to check if both brows are equal and symmetrical look from a distance to be sure
03:24what they are equal the next step is to see what access is
03:27you
