00:00Z-series can be equipped with four centrifugal nozzles to screen together and realize front or rear spring.
00:07The installation steps are as follows.
00:10Cable Installation
00:11Step 1. Disassemble the two centrifugal nozzles, disconnect the connecting, and remove the nozzle cables from the drums.
00:19Step 2. Insert 1-2 nozzle adapter cable on the rear circuit board and the long one connect to the right socket.
00:28Then thread the other two wires to the front.
00:32Remove the buckle to thread the wires and water hose into the M1 and M2 arms respectively.
00:39Note the water hose should be behind the arm.
00:43Then restore the motor signal lights in the buckle.
00:48Step 3. Insert another short 1-2 cable into the left socket of the rear circuit board
00:55and pass it through the M3 and M4 arms.
00:58Then insert it into the motor socket and restore the nozzles.
01:03Nozzle Installation
01:05Step 1. Install the centrifugal nozzle under the arms of M1 and M2.
01:11Disassemble the nozzle, and then pass the wire through the bracket.
01:16Ensure that the notch faces upward, then fix it with screws.
01:21Step 2. Connect the cable to the nozzle, and fix the nozzle and bracket with screws.
01:27Step 3. Insert the water hose into the pneumatic connector.
01:32Water Hoses Installation
01:34Step 1. Disconnect the water hoses at the bottom of the tank, and connect the T to the water hose at the M3 arm.
01:42Then use the water hose to connect the outlet of flow meter.
01:47Step 2. Pass the water hose from the bottom of the tank to connect the T.
01:53Another end to connect the hose at M4 arm by an elbow.
01:58Step 3. Connect a water hose to another flow meter outlet.
02:03Then passing through the bottom of the tank and connect it to the M1 arm water hose by a T.
02:10And the other end connects to the M2 arm water hose by a water hose and an elbow.
02:20Spring Debugging
02:21Step 1. Open the EFT agree app.
02:24Step 2. In the spring settings, select the 4 nozzles mode, and choose auto mode.
02:30Step 3. Then, take off the drone and press button B to start spring.
02:34Step 4. Take the flight direction as the front and ensure that always the rear two nozzles keep spring.
02:41Step 5. If choose auto mode, press B, and after the drone takes off, 4 nozzles will spring simultaneously during the flight.
02:51Step 6. No matter which mode of the 4 nozzles spring, always we select the spring mode as fixed or as follow speed.
03:00Once all 4 nozzles are spring properly, the debugging is complete.
03:05Follow us to get more practical tutorials and updates.
Comments