Fix smartphone microphone not working problem DIY

GET INFORMATION AND KNOWLEDGE

Hi, viewers in this video I am going to show you how you can fix the problem which is smartphone microphone not working problem by yourself at home. So, viewers watch this video till the end.

Transcript

00:00hi viewers in this video I am going to show you fix for the problem which is that when you make

00:09a call or receive a call through dialpad or any internet based app your voice is not audible so

00:21viewers watch this video till then my name is Sazam Antanoli welcome to get information and

00:26knowledge YouTube channel let's get started viewers you can see that the call is incoming I will answer

00:34it it's on whatsapp you will see that the caller will not be able to hear my voice the smartphone

00:51which I'm using which has a mic problem is Samsung Galaxy A32 right now you can see it it has the mic

00:59at the bottom right side to fix mic not working problem you will need number one a heat gun or

01:06hair dryer number two a suction cup number three guitar pick or plastic pry tool number four

01:17Phillips number double zero screw driver number fifth is Samsung Galaxy A32 charging board number

01:29sixth t-7000 adhesive number seven is glue remover tool and tweezer number eight is transparent packing

01:39tab now make sure that you are static free and power off your smartphone and

01:46and take out the same tray of your smartphone then you have to start removing the big cover of your

01:55smartphone to remove it first of all you have to use the heat gun or hair dryer it will be used

02:07to soften the adhesive around the glass back

02:10then you have to use also the suction cup it will be used to gently lift the glass once the adhesive is

02:19soft next is ketorpic or plastic pry tool it will be used to slide around edges and fully separate glass

02:29do these steps very carefully because if you don't do it properly the back cover is of glass it might break

02:40after removing the back cover you have to start removing the screws using the phillips number double zero

02:48screwdriver after removing the screws you have to remove the middle frame of your smartphone

02:57after that you have to start disconnecting the cables first one is the battery cable second one is the main

03:15board flex cable third one is the antenna cable after disconnecting the cables you have to remove the screw

03:24of the charging board and then you have to replace it with the new charging board then secure the new charging

03:34board with the screw and then connect all the cables

03:41then reattach the middle frame and put the screws back into the middle frame

03:58after that now you have to do the testing insert the sim tray and then power on your smartphone and then

04:13make a call using the dial pad or internet based app in my case i will receive a call

04:24through internet based app which is whatsapp and test the mic

04:30you will see that my mic will work perfectly hello

04:34after that we were using the glue remover tool and tweezer you have to clean the corners

04:53of your smartphone so that there does not remain any adhesive

05:12then you have to also clean the corners of the back cover of your smartphone then apply t7000 adhesive at the corners of your smartphone

05:42you

05:47after that place the back cover on the back of your smartphone

05:54then at the end to secure the fit apply tape at the corners of your smartphone

06:09the back cover of your smartphone

06:12viewers hope so you liked my this video if you are new on my youtube channel

06:16then don't forget to subscribe and click or tap on the notification bell on all

06:20to get the notification of my latest uploaded information and knowledge videos

Category

Transcript

Be the first to comment

Recommended