00:00Paul told me not to share these tricks with anyone one to fix a pipe in an open outdoor area
00:05bury a broken bucket underground first pour concrete mortar as the foundation then cut a fitting hole on one end
00:13of a PVC pipe and a slot on the other end place it over the pipe as a casting mold
00:18fill it with cement mortar it becomes a frost proof insulated concrete support post to use a door bolt to
00:25mark the locking position in concrete embed a short pipe section
00:29into the hole after the concrete fully cures cut off the part above ground enlarge one end of the metal
00:36pipe with an all seal the bottom with a wooden wedge inserted into the embedded pipe it can be cleaned
00:43easily and prevents the bolt hole from clogging three when a water pipe develops a hole cut a bicycle inner
00:50tube into a rubber patch apply glue and use a toothpick to place it inside the pipe as a base
00:56seal then collect plastic shavings from old pipes
00:59mix them with waterproof adhesive and stir thoroughly into a thick paste apply it to the outer surface to fill
01:07uneven gaps once cured the pipe regains full waterproof sealing for burn a round hole in the bottom of a
01:15wash basin insert the top half of a plastic bottle into the hole seal all edges with hot glue to
01:22prevent leaks connect a drainage hose install it under a faucet setup this creates a low cost
01:29DIY sink 5 to connect pipes of the same diameter insert a screw rod into the rigid pipe first heat
01:37the pipe until it becomes fully soft wrap wire around the softened pipe for shaping cool it with water to
01:44set the shape cut off the expanded excess
Comments