Bushcrafty Flissa

Modified to be more Bushcrafty

Transcript

00:00all right a slightly modified and bushcrafty

00:08I literally 3d printed a ferro rod mount

00:15Gorilla glued it to the sheath

00:20put a hole in it put a screw in it

00:25so that's a very solid ferro rod mount now

00:31as for this the spine I put it on a diamond plate

00:38just very carefully honed it slowly

00:42just to make the edge a little bit more crispy

00:45because last time on Gumtree was pretty poor

00:49so let's see how it goes

00:55that's pretty nice

01:20just clean that out very cleanly and carefully

01:30the knot right there so I went through that reasonably well

01:38just a little bush crafty there

01:54not much effort to get a nice pile of scrapings

02:00very little effort which is always nice

02:12I'm going to use this ferro rod since this is well used

02:18try and get a good angle on this

02:28and it went out

02:32oh that was a big one

02:34look at that

02:36that was brutal

02:38that was brutal

02:40that was brutal

02:42that was brutal