Motorized T/P/S Jib (Phase I)

ZamanQ8

by ZamanQ8

0
40 views
  • About
  • Export
  • Add to
My aim is to build a motorized Tilt, Pan, and Slide jib camera base or jib crane.

Here is a breife of what you see in this video clip (Phase One):

-Modeling by using PVC 4" end cap glued from inside down by 1" pvc end cap or connector. and as for the raised shaft I used 2cm thickness wood as its shown.

- Molding the model by junk and selvage melted aluminum into fine sand negative of the model itself.

- Lathing job for the base and beneath shaft

Phase two coming soon... Enjoy this one so far :)

,,,Regards

0 comments