6 years ago41 views
My aim is to build a motorized Tilt, Pan, and Slide jib camera base or jib crane.
Here is a breife of what you see in this video clip (Phase One):
-Modeling by using PVC 4" end cap glued from inside down by 1" pvc end cap or connector. and as for the raised shaft I used 2cm thickness wood as its shown.
- Molding the model by junk and selvage melted aluminum into fine sand negative of the model itself.
- Lathing job for the base and beneath shaft
Phase two coming soon... Enjoy this one so far :)